This is the long awaited and much anticipated F7 flight controller from Matek Systems bundled with the FCHUB-6S.
F722-STD
Considering its size (36mm x 36mm) and weight (7g), there's a lot to like about this FC board. Offering the all important flight controller, barometer, gyro, OSD, SD slot, Blackbox, camera control, RSSI, and beeper, you're definetly getting your monies worth. And, with its impressive credentials, it handles exceptionally well.
There are sure to be quite a few drone racing pilots upgrading to this FC.
The F722-STD is designed to connect easily to both the the FCHUB-6S and the FCHUB-VTX, which is available separately. Click here for the FCHUB-6S.
FCHUB-6S
Designed to work with Matek Systems F722-STD FC flight controller, the FCHUB-6S is a neatly combined PDB and BEC in one.
The PDB supports up to 6S Li-Po battery input, and features a 184A current sensor, along with both a 5V and 10V BEC; outputting 2A max.
Matek Systems are market leaders in this category and this power distribution board is evidence of that.
Matek Systems Flight Controller F722-STD & FCHUB-6S
Specification:
Brand name: Matek Systems
Item name: F722-STD flight controller
36x36mm PCB with 30.5mm mounting holes
Weight: 7g
MCU: 216MHz STM32F722RET6
IMU: 32K ICM20602 gyro/accelerometer (SPI)
Baro: BMP280 (I2C)
OSD: BetaFlight OSD w/ AT7456E chip
Blackbox: MicroSD card slot (SD/SDHC)
VCP, UART1, UART2, UART3, UART4, UART5
PPM/UART Shared: UART2-RX
Battery Voltage Sensor: 1:10
Current Sensor: No (FCHUB-6S, FCHUB-VTX option)
BEC 5V: No (FCHUB-6S, FCHUB-VTX option)
LDO 3.3V: Max.300mA
I2C1 SDA & SCL: Yes
Camera control: Yes
DAC: Yes
WS2812 Led Strip : Yes
Beeper : Yes
RSSI: Yes
Features F722-STD:
3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
7x PWM / DShot outputs without conflict
5x UARTs
1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
1x I2C1
4x pairs of corner pads for ESC Signal/GND connections (DSHOT compatible)
1x Side-press button for BOOT(DFU) mode
1x 16pin bottom mounted FFC Slot for FCHUB-6S or FCHUB-VTX connectionKey Features FCHUB-6S
- 9-27V (3-6S Lipo) Input
- Supports a continuous current of 184A
- TVS diode for over voltage protection
- 184A Current Sensor
- 5V BEC at 2A
- 10V BEC at 2A
- Stacks with the F405-OSD flight controller
- Includes nylon standoffs
Package includes:
1x F722-STD flight controller
2x 0.5mm*16Pin 5cm Flexible Flat Cable
4x M3 Anti-vibration Standoffs1x FCHUB-6S
4x M3x12
4x M3x6+6
8x M3 nuts
SD Card (not included) Requirements: